Looking for the brightest?
We have created a better MONSTER
click HERE for details

E - Series
Our E-Series lights have a potentiometer for manual intensity adjustment. They have both a PNP or a NPN input for strobing the lights. The strobe inputs are pulse width controlled from an external device (usually a PLC, Industrial PC or Smart camera). Either input can be connected for the light to run in continuous mode. E-Series lights have a 0-10VDC analog input for intensity control. The analog input is revolutionary because it works using reverse logic. 0VDC is 100% intensity and 10VDC is 0% intensity. An analog input signal is not required to achieve 100% light output.
E-Series lights run on standard 24VDC industrial power supplies.
E-Series lights incorporate our patent pending Micro Driver with burst. No external driver, overdrive controller or single purpose overdrive light is needed.
E-Series lights are configured with the highest output LED's available.
E-Series lights have an auto resetting circuit built in to protect the LEDs against damaging over temperature environments and situations (exceeding the burst duty cycle specifications).
E-Series lights are configured to overdrive the LEDs. The burst mode can be disabled by a dip switch. When either strobe input is enabled the burst circuit will overdrive the LEDs for 500 microseconds before dropping to a safe continuous current for the LEDs.
E-Series lights utilize Spectrum Illumination's new patent pending Aluminum Single Interface Housing. We have eliminated the extra enclosure components by forming the thermally conductive housing from the aluminum circuit board. The cost savings and performance benefits are the result of this revolutionary design.

X - Series
Spectrum Illumination eXtreme Series Spot Lights are the same as the E – Series Spot Lights except they use extreme intensity large junction LED’s. The white models features a 10 watt LED with burst current at 5 amps! The IR model features a double stacked die for nearly double mW output at same drive current as our standard IR LED’s. Burst current for the eXtreme IR spot light is 3.85A!

SP - Monster Series
Spectrum Illumination Monster Series Spot Lights are used for both bright field and dark field illumination. The Monster Series Spot Light was designed to be used for applications requiring a large area of coverage and/or a long working distance. Typically, they are used in applications that need a lot of light and can be mounted 12" (304.8mm) to 20' (6,096mm) from the desired area of interest. LED optics and diffuser options are also available on these lights that make it possible to obtain closer working distances and/or larger coverage areas. Every light is designed in a heavy duty industrial enclosure. The Monster Series Spot Lights can be purchased in standard sizes starting at 1.25" (31.75mm) up to 5.5" (139.7mm). The Monster Spot Lights are supplied with our DIN rail mount 24 volt DC High Speed LDM (LED Driver Module) Adapter and a 4 meter 5 pin reverse keyed M12 Eurofast quick disconnect cable. The LDM Adapter has both PNP and NPN strobe inputs with a 3 microsecond response time and is also available with an optional variable potentiometer control or 0-10VDC analog control.